How to use and choose a suitable operating table

     The operating table should have very good mobility. It should be designed with four wheels on the ground, which is convenient to move, and has a central mechanical brake device. The casters are locked or released through the center of the foot lever. The electric operating bed is suitable for “conventional, surgical, and medical process patient name support table”, which is also the patient support during the operation. The driving method has two methods: motor drive and mechanical manpower drive. One of the characteristics of these products is used in “surgery, in the mechanical strength of the electric operating room bed, it is required that the surgical table can withstand 2.2 times the safe working load without deformation.

　　The bearings of the electric induction operating table are all sealed, waterproof and easy to clean. The water, blood and sutures during the operation will never be entangled in the bearings. The bed base of the electric operating table adopts a Y-shaped design to ensure that the operating table has high stability and free space, so that the medical staff can get close to the surgical patient at zero distance. Head-to-foot tilt and left-to-right tilt only need to gently pinch the head handle to obtain the clinically required posture. Both the leg plate and back plate joints are equipped with a gas spring cylinder support structure, which makes various adjustments gentle, silent, and vibration-free. At the same time, it effectively maintains the joint structure and prevents the patient from falling.

　　 Tips:

　　 1. The electric operating table is purchased. The bed surface is made of 1.2 mm thick cold-rolled steel plate, which is formed by one-step stamping and has no solder joints on the outside.

　　 2. When purchasing an electric operating table, you should choose a linear motor with a safe voltage, which has relatively stable performance and has a battery, which can work for four hours even if the power is cut off.

　　3. The head and foot of the electric operating bed should be blow-molded integrally with high-quality materials. The switch is set on the outside, which can be easily installed and unloaded, and the head card can also be inserted.