• Application range of operating table

Application range of operating table

 The operating table should have very good mobility, choose four-wheel landing design, easy to move, and has a central mechanical brake device, the casters are locked or released through the center of the foot lever. The electric operating table is suitable for "conventional, surgical, and medical process patient name support table", which is also the patient support during the operation process. There are two driving methods: motor drive and mechanical manpower drive. One of the characteristics of these products is used in "surgery. In the mechanical strength of the electric operating table, the operating table is required to accept 2.2 times the safe working load without deformation.

  The bearings of the electric induction operating table are all sealed, waterproof and easy to clean. The water, blood and sutures during the operation will never be entangled in the bearings. The bed base of the electric operating table adopts a Y-shaped design to ensure that the operating table has high stability and free space, so that the medical staff can get close to the surgical patient at zero distance. Head-to-foot tilt and left-to-right tilt only need to gently pinch the head handle to obtain the clinically required posture. Both the leg plate and back plate joints are equipped with a gas spring cylinder support structure, which makes various adjustments gentle, silent, and vibration-free. At the same time, it effectively maintains the joint structure and prevents the patient from falling.


   1. The size of the electric operating table to be purchased should be 2200×900×500 mm. The bed surface is made of 1.2 mm thick cold-rolled steel plate, which is formed by one-step stamping and has no solder joints on the outside.

   2. When purchasing a generalized electric operating table, you should choose a linear motor with a safe voltage, which has relatively stable performance and has a battery, which can work for four hours even if the power is cut off.

   3. The head and foot of the electric operating bed should be blow-molded integrally with high-quality materials. The switch is set on the outside, which can be easily installed and unloaded, and can also be inserted into the head card.


Post time: Oct-12-2021

Send your message to us:

Write your message here and send it to us